Installation guide

3-10
ESCALA T610 and PL 600T Installation Guide
8. When you are instructed to install the adapter in the adapter slot, carefully grasp the
adapter by the edges and align the adapter in the slot guides. Insert the adapter fully into
the adapter slot connector. If you are installing a full–length adapter, ensure that both
ends of the adapter engage the card guides.
9. Lower the plastic stop over the adapter bracket and rotate the locking latch clockwise
until it clicks into the locked position. Some full–length cards can be supported by
rotating the blue adapter latch on the right end of the adapter divider counterclockwise.
10.Connect appropriate cables and devices to the adapter.
11.Continue to follow the screen instructions until you receive a message that the
installation is successful. Successful installation is indicated by the OK message
displayed next to the Command field at the top of the screen.
12.Press the F3 key to return to the PCI Hot–Plug Manager menu.
13.Select Install/Configure Devices Added After IPL and press Enter. Then follow the
instructions on the screen.
14.Press F10 to exit the Hot–Plug Manager.
If you have added, removed, or replaced any adapters, run the diag –a command. If the
system responds with a a menu or prompt, follow the instructions to complete the device
configuration.
15.If you have other options to install, refer to ”Option List” on page 3-3.
16.If you do not have other options to install, replace the system unit covers as described in
”Replacing Covers” on page 3-48.