Installation guide

3-4
ESCALA T610 and PL 600T Installation Guide
Removing the Covers
Note: Some procedures can be performed while the system power is on. Refer to
”Hot–Pluggable Options” on page 3-2 to determine if the device you are installing is
hot–pluggable.
If the option you are installing is:
– A hot–pluggable device, then you can proceed to the next step.
– not a hot–pluggable device, then shut down the system as described in ”Stopping the
System Unit”. on page 3-2.
1. To remove the front cover, grasp the cover at the top and pull the top out far enough to
clear the front of the system.
2. Lift up the front cover to disengage the tabs on the bottom.