Installation guide

2-2
ESCALA T610 and PL 600T Installation Guide
9. When the Diagnostic Operating Instructions display, go to ”Step 3. Running System
Verification”.
Note: If you are unable to load the diagnostics to the point when the Diagnostic Operating
Instructions display, call your support center for assistance.
Step 3. Running System Verification
When the Diagnostic Operating Instructions display, do the following to run system
verification:
1. Press Enter.
2. If the terminal type has not been defined, you must use the Initialize Terminal option on
the Function Selection menu to initialize the operating system environment before you
can continue with the diagnostics.
3. If you want to do a general checkout with minimal operator action, select the Diagnostic
Routines option on the Function Selection menu.
If you want to do a more complete checkout including the use of wrap plugs, select the
Advanced Diagnostics option on the Function Selection menu. The advanced
diagnostics are primarily for the service representative; the diagnostics may instruct you
to install wrap plugs to better isolate a problem.
4. Select the System Verification option on the Diagnostic Mode Selection menu.
5. If you want to run a general checkout of all installed resources, Select the All Resource
option on the Diagnostic Selection menu. Follow the instructions on the screen to
complete the checkout procedure.
If you want to check one particular resource, select that resource on the Diagnostic
Selection menu.
The checkout programs end with either of the following results:
• The Testing Complete menu displays with a message stating No trouble was found.
• The A Problem Was Detected On (Time Stamp) menu displays, with either a service
request number (SRN) or an error code. Make a note of any codes displayed on the
display or operator panel.
Step 4. Performing Additional System Verification
To perform additional system verification, do the following:
1. Press Enter to return to the Diagnostic Selection menu.
2. If you want to check other resources, select the resource. When you have checked all of
the resources you need to check, go to ”Step 5. Stopping the Diagnostics”.