Installation guide

1-16
ESCALA T610 and PL 600T Installation Guide
Step 19. Start the Operating System
To start the installed AIX operating system, open the door to the operator panel and locate
the power on/off button (1).
1
1. Press the power on/off button on the operator panel.
– The power LED on the operator panel starts blinking at a fast rate.
– Checkpoint codes (9xxx) appear in the operator panel display.
– When the power–on sequence is complete, the power LED stops blinking and stays
on.
– The AIX operating system loads and you are ready to use your system.
Refer to the AIX documentation for information about using AIX. This documentation is
located on the Hypertext Library CD. The documentation information is made accessible by
loading the documentation CD onto the hard disk or by mounting the CD in the CD–ROM
drive.
Step 20. Verify the Hardware Operation
If your system did not load the AIX operating system successfully, or you would like to test
your hardware, go to Chapter 2, ”Verifying the Hardware Operation”.