Installation guide

1-10
ESCALA T610 and PL 600T Installation Guide
Step 13. Connect the Graphics Display
Note: If you are using an ASCII terminal as the console for this system, and do not have a
graphics display to connect, continue with ”Step 15: Connect the Adapter Cables” on
page 1-11.
As shown in the following figure: connect the graphics display cable to the back of the
display and to the graphics adapter connector.
For more information about your display, refer to the documentation included with the
display.
Note: Some displays require an additional cable.
Step 14. Attach the Display Cable Toroid
If the cable for your display does not include a toroid, locate the toroid shipped with your
system unit and follow the installation instructions included with the toroid.