Installation guide

1-9

Setting Up the System

Step 11. Connect Any Additional External SCSI Devices

1. Locate the last SCSI device in the chain from the system unit. If a SCSI device

terminator (1) is installed, remove it.

2. Connect the new SCSI cable (2) where you just removed the SCSI bus terminator.

3. Connect the other end of the SCSI cable (3) to the new SCSI device.

4. Connect the SCSI bus terminator (4).

5. Refer to the SCSI device documentation to set the SCSI device address. For future

reference, you can record the address in Appendix D, ”System Records”.

6. Repeat this step for each additional SCSI device you attach.

Step 12. Check your Display Type

Note: If you are using an ASCII terminal as the console for this system, and do not have a

graphics display to connect, continue with ”Step 15: Connect the Adapter Cables” on

page 1-11.

If you ordered a graphics display with your system unit, the system unit has been set to use

the highest display resolution and refresh rate available for that display. If you want to:

• Attach a different display to your system unit

• Change the default display resolution or refresh rate

then, after completing the installation steps, refer to the documentation for your graphics

adapter and change the settings for your display..