Installation guide

1-8

ESCALA T610 and PL 600T Installation Guide

Step 10. Connect the First External SCSI Device

Note: If you have no SCSI devices to attach, continue with ”Step 12: Check Your Display

Type” on page 1-9.

1. Connect the SCSI cable to the Ultra 2 SCSI LVD SCSI connector (1).

2. Connect the other end of the SCSI cable to the SCSI device (2).

3. If this is the last SCSI device on this SCSI cable, connect the SCSI bus terminator (3).

Note: The built–in SCSI interface is Ultra2 SCSI. When a cable is not attached to the SCSI

connector on the system unit, the connector is automatically terminated.

4. Refer to the SCSI device documentation to set the SCSI device address. For future

reference, you can record the address in Appendix D, ”System Records”.