Installation guide

1-3
Setting Up the System
DANGER
To prevent electrical shock hazard, disconnect the power cable from the
electrical outlet before relocating the system.
Step 5. Position the System Unit and Display
Position the system unit and display (optional) at or near their installed location.
Observe the following guidelines when you are positioning the system unit:
• The system unit weighs between 30 kg (65 pounds) and 95 kg (209 pounds). The unit is
not intended to be lifted or handled except by trained personnel. Do not try to lift the
system unit by yourself.
• Displays or ASCII terminals can weigh as much as 35 kg (77 pounds). Use caution when
lifting or moving the display or ASCII terminal.
• Leave enough space around the system unit to safely and easily complete the setup
procedures.
• Observe standard ergonomic guidelines while arranging your system unit so that you can
work comfortably and safely.
• Be sure to maintain at least 51 mm (2 inches) of space on the sides of the system unit
and 152 mm (6 inches) at the rear of the system unit to allow the system unit to cool
properly. The front of the system requires a minimum of 76 mm (3 inches) of space.
Blocking the air vents can cause overheating, which might result in a malfunction or
permanent damage to the system unit.
• Place the system unit in a location where it can safely and easily reach any necessary
power outlets and network connections.
• Place the display or ASCII terminal in a stable and sturdy location.