Installation guide

4-30
HiSpeed WAN Comm. Installation and Service Guide
Add an SVC IP/HiSpeed WAN Comm. Host Entry
Add an SVC host entry to the IP/HiSpeed WAN Comm. translation table.
A switched virtual circuit is a pair of logical channels which exists only for the duration of the
call.
Add IP / Hispeed WAN Comm SVC Host Entry
* Remote HOSTNAME []
* Remote DTE Address [] #
* X25 Device Number +
–––––––––– Optional X.25 Facilities ––––––––––
RECEIVED data PACKET size +
TRANSMITTED data PACKET size +
RECEIVED data WINDOW size [] #
TRANSMITTED data WINDOW size [] #
CLOSED USER GROUP selection [] #
CLOSED USER GROUP WITH OUTGOING ACCESS selection [] #
User–Defined Facilities and CALL USER Data []
Note: This menu may be accessed directly, using the command: smit mkx25ds
Remote Hostname [no default value]
Specify the host name, expressed in alphanumeric value, to add to the translation table.
Remote DTE Address [no default value]
Specify the X.25 address (network-layer) or NUA of the remote host.
Valid values are 1 to 15 ASCII decimal digits (X.121 address).
X.25 Device Number [no default value]
Specify the local HiSpeed WAN Comm. port number to be used by the SVC.
Refer to HiSpeed WAN Comm. Adapters and Ports Numbering on page E-1.
Range of possible values
0 to 31
Optional X.25 Facilities
Definition of the attributes relative to the X.25 optional facilities which may be set up at the
call establishment.
Received data packet size [no default value]
Maximum received packet size to be used with the virtual circuit. The received data packet
size refers to the size of the packets the calling DTE wants to receive from the called DTE.
List of possible values
16 32 64 128 256 512 1024 2048 4096
Transmitted data packet size [no default value]
Maximum transmitted packet size to be used with the virtual circuit. The transmitted data
packet size refers to the size of the packets the calling DTE wants to transmit to the called
DTE.