User`s guide

Universal Serial Bus (USB)
Four Universal Serial Bus ports
(USB 0/1, 2/3) are located on
the I/O back panel. In addition,
three USB headers, located close
to the I-SATA ports,
provide two
front-accessible USB connections
(USB 4/5). A Type A connector
(USB 6) also supports front panel
USB connections. (Cables are
not included). See the tables on
the right for pin definitions
Serial Ports
Two COM connections (COM1
&
COM2) are located on the
serverboard. COM1 is located
on the rear I/O
panel. COM2,
located next to the IPMB
header, is
used to provide front access
support. See the table on the
right for
pin definitions.
Ethernet Ports
Two 1 Gigabit Ethernet ports
(JLAN1/2) are located on the
I/O backplane. In addition, a
dedicated IPMI
LAN port, located
above the USB 0/1 ports on the
backplane, provides KVM
support
for IPMI 2.0. All these ports
accept RJ45 type cables.
Note: Please refer to the LED
Indicator Section for LAN LED
information.
40
bullx R423-E3 - Installation and User's Guide