User`s guide
Table Of Contents
- NovaScale 4020 User's Guide
- Preface
- Contents
- 1 System Description
- 2 Board Set Description
- 3 Configuration Software and Utilities
- Utilities / Drivers on Resource CD
- Power-on Sequence and Power-on Self-Test (POST)
- Extensible Firmware Interface Boot Manager
- The Extensible Firmware Interface (EFI) Shell
- BIOS Setup
- LSI Logic* SCSI Utility
- System Maintenance Utility
- EFI Platform Diagnostic Tests
- EFI Service Partition
- Console Redirection
- Terminal Mode
- Shutting Down the Server
- Servicing the System (basic knowledge)
- A Warning and Cautions
- B Working Inside the System
- C Hot-swapping System Components
- D Servicing the Electronics Bay
- Safety Warnings
Configuration Software and Utilities 83
Viewing Events in the SEL
When the SEL Viewer is opened, the first page of events is loaded from the log and displayed.
To view the remaining events you are provided with a series of buttons along the bottom of the
screen. You can use the <Tab> key to access the screen buttons.
Acronym Description
RID Record ID
RT Record Type
TS Time Stamp
GID Generator ID
ER Event Message Format Revision
ST Sensor Type
SN Sensor Number
EDIR Event Dir and Event Type
ED1 Event Data 1
ED2 Event Data 2
ED3 Event Data 3
MID Manufacturer ID
1
OEM OEM defined
2
Figure 45. SEL Viewer, Hex Display Mode
Home Button
The Home button displays the first segment of events. This button is disabled if the first event
is displayed.
1
Used when displaying OEM SEL Records Type C0h-DFh
2
Used when displaying OEM SEL Records Type C0h-DFh and E0h-FFh