User`s guide
Table Of Contents
- NovaScale 4020 User's Guide
- Preface
- Contents
- 1 System Description
- 2 Board Set Description
- 3 Configuration Software and Utilities
- Utilities / Drivers on Resource CD
- Power-on Sequence and Power-on Self-Test (POST)
- Extensible Firmware Interface Boot Manager
- The Extensible Firmware Interface (EFI) Shell
- BIOS Setup
- LSI Logic* SCSI Utility
- System Maintenance Utility
- EFI Platform Diagnostic Tests
- EFI Service Partition
- Console Redirection
- Terminal Mode
- Shutting Down the Server
- Servicing the System (basic knowledge)
- A Warning and Cautions
- B Working Inside the System
- C Hot-swapping System Components
- D Servicing the Electronics Bay
- Safety Warnings
78 NovaScale 4020 User’s Guide
Dial String
This drop-down list shows all destination dial strings. The string selected before you clicked
Edit on the Page Destination Configuration screen is displayed.
Flow Control
This drop-down configures the data flow control. Available choices are No Flow Control,
CTS/RTS (hardware handshake), and XON/XOFF.
Baud Rate
This drop-down determines the maximum rate in bits per second at which the data can be
transmitted through the serial port. Available baud rates are 9600, 19200, 38400, 57600,
and 115200 bps.
Stop Bits
This drop-down determines the number of stop bits to use when transmitting page data. The
choices are 1 or 2 stop bits.
Data Bits
This drop-down determines the number of data bits to use when transmitting page data. The
choices are 7 or 8 data bits.
Parity
This drop-down determines the parity type that is used when transmitting the page data. The
choices are None, Odd, or Even.
Call Retries
This edit box is the number of times to retry calling the destination specified by the destination
dial string. A value of zero indicates no retries (the call is only made once).
Enter a value between 0 and 7.