User`s guide
Table Of Contents
- NovaScale 4020 User's Guide
- Preface
- Contents
- 1 System Description
- 2 Board Set Description
- 3 Configuration Software and Utilities
- Utilities / Drivers on Resource CD
- Power-on Sequence and Power-on Self-Test (POST)
- Extensible Firmware Interface Boot Manager
- The Extensible Firmware Interface (EFI) Shell
- BIOS Setup
- LSI Logic* SCSI Utility
- System Maintenance Utility
- EFI Platform Diagnostic Tests
- EFI Service Partition
- Console Redirection
- Terminal Mode
- Shutting Down the Server
- Servicing the System (basic knowledge)
- A Warning and Cautions
- B Working Inside the System
- C Hot-swapping System Components
- D Servicing the Electronics Bay
- Safety Warnings
Configuration Software and Utilities 77
Enable Paging
This check box enables paging for the serial/modem channel.
Page Blackout Interval
The Page Blackout Interval determines the minimum number of minutes between pages. It
provides a way to prevent back-to-back pages if a rapid series of events occurs. This parameter
is entered in minutes; a value of 0 indicates no blackout.
Enter a value between 0 and 255.
Call Retry Interval
This setting gives the number of seconds between call retries when a busy signal is detected.
Enter a value between 0 and 255.
Edit Page Destination
When you select a Dial String on the Page Destination Configuration screen and then click
Edit, you are shown the Edit Page Destination screen. On this screen, you configure or
modify the settings for the selected page destination.
Figure 42. Edit Page Destination
After completing this screen, click OK to return to the Page Destination Configuration screen.