User`s guide
Table Of Contents
- NovaScale 4020 User's Guide
- Preface
- Contents
- 1 System Description
- 2 Board Set Description
- 3 Configuration Software and Utilities
- Utilities / Drivers on Resource CD
- Power-on Sequence and Power-on Self-Test (POST)
- Extensible Firmware Interface Boot Manager
- The Extensible Firmware Interface (EFI) Shell
- BIOS Setup
- LSI Logic* SCSI Utility
- System Maintenance Utility
- EFI Platform Diagnostic Tests
- EFI Service Partition
- Console Redirection
- Terminal Mode
- Shutting Down the Server
- Servicing the System (basic knowledge)
- A Warning and Cautions
- B Working Inside the System
- C Hot-swapping System Components
- D Servicing the Electronics Bay
- Safety Warnings
74 NovaScale 4020 User’s Guide
Destination Dial Strings
The screen shown below displays the current setting of each destination dial string available on
the target platform. For the NovaScale 4020 Server, up to six dial strings can be configured.
A dial string can be modified or cleared by selecting the corresponding radio button and then
clicking on the Edit button.
Figure 39. Destination Dial Settings
After completing this screen, click Next to move to the next screen to continue this sub-task.
New, Edit, and Delete Buttons
If no dial strings are configured, only the New button is enabled.
• New: When the New button is clicked, you are shown a screen where you can configure a
new dial string. See the following section for details.
• Edit: If you select a dial string and then click the Edit button, you are shown a screen
where you can edit the selected dial string. See the following section for details.
• Delete: If you select a dial string and then click the Delete button, the selected dial string
is deleted. Before deleting the dial string, you are prompted by a confirmation prompt. If
you click OK to confirm deleting the dial string, the Destination Dial Strings screen is
redisplayed with the deleted dial string no longer shown.