User`s guide

70 NovaScale 4020 User’s Guide
•
C: If the alert to the previous destination was successful, do not send an alert to the
destination referenced in the current policy table entry. Stop processing policy table entries.
• D: If the alert to the previous destination was successful, do not send an alert to the
destination referenced in the current policy table entry. Instead, proceed to the next policy
table entry that has the same policy number, but has a different channel destination.
• E: If the alert to the previous destination was successful, do not send an alert to the
destination referenced in the current policy table entry. Instead, proceed to the next policy
table entry with the same policy number that has a different destination type.
Select the Destination
This set of radio buttons shows the possible channel destinations that can be associated with a
policy table entry. Each radio button is associated with a drop-down list of destinations that
have been configured for that channel. Only the selection made in the drop-down list associated
with the active radio button (channel) is used.
Serial/Modem Channel Configuration Sub-task
The serial/modem channel configuration sub-task allows you to modify settings that relate to
the serial/modem channel, set up dial strings to which alerts are sent, and specify the settings
related to sending alerts to those destinations.
This sub-task includes a screen that allows you to configure the settings for the terminal mode
of operation of the serial/modem channel.
Figure 37. Serial / Modem Channel Configuration
After completing this screen, click Next to move to the next screen to continue this sub-task.
The screen that is displayed when the Next button is clicked depends on which connection
mode is chosen:
• If modem mode is selected, the next screen displayed allows setup of modem parameters
• If direct connect is selected, since there are no configuration parameters to set, the next
screen displayed is the Destination Dial Strings screen.