User`s guide
Table Of Contents
- NovaScale 4020 User's Guide
- Preface
- Contents
- 1 System Description
- 2 Board Set Description
- 3 Configuration Software and Utilities
- Utilities / Drivers on Resource CD
- Power-on Sequence and Power-on Self-Test (POST)
- Extensible Firmware Interface Boot Manager
- The Extensible Firmware Interface (EFI) Shell
- BIOS Setup
- LSI Logic* SCSI Utility
- System Maintenance Utility
- EFI Platform Diagnostic Tests
- EFI Service Partition
- Console Redirection
- Terminal Mode
- Shutting Down the Server
- Servicing the System (basic knowledge)
- A Warning and Cautions
- B Working Inside the System
- C Hot-swapping System Components
- D Servicing the Electronics Bay
- Safety Warnings
Configuration Software and Utilities 65
Event Filter Settings
The PEF Event Filters Settings screen, shown in the figure below, displays the supported
pre-configured event filters, along with settings associated with the event filters. These
associated settings are:
• Whether the filter is enabled or disabled.
• The policy number associated with the filter (required only if alerts are enabled).
• A chassis action that occurs if the filter event occurs.
• Whether alerts are enabled or disabled if the filter event occurs.
The settings associated with a particular filter can be edited. Select the radio button next to a
filter and then clicking the Edit button.
Figure 33. Event Filter Settings
If you click in one of the radio buttons and then click Edit, the Edit Event Filter Settings screen
is displayed for the selected event filter. After completing this screen, click Next to move to
the next screen to continue this sub-task.