User`s guide
Table Of Contents
- NovaScale 4020 User's Guide
- Preface
- Contents
- 1 System Description
- 2 Board Set Description
- 3 Configuration Software and Utilities
- Utilities / Drivers on Resource CD
- Power-on Sequence and Power-on Self-Test (POST)
- Extensible Firmware Interface Boot Manager
- The Extensible Firmware Interface (EFI) Shell
- BIOS Setup
- LSI Logic* SCSI Utility
- System Maintenance Utility
- EFI Platform Diagnostic Tests
- EFI Service Partition
- Console Redirection
- Terminal Mode
- Shutting Down the Server
- Servicing the System (basic knowledge)
- A Warning and Cautions
- B Working Inside the System
- C Hot-swapping System Components
- D Servicing the Electronics Bay
- Safety Warnings
Board Set Description 25
PCI Riser Board
The PCI riser board connection layout is displayed in Figure 19. It supports the following
features:
• One Server I/O Hub (SIOH) component of the E8870 chip set
• One P64H2 component
• Three non-hot-plug PCI slots
One 64-bit, 133 MHz PCI-X, full length
Two 64-bit, 100 MHz PCI-X, full-length
• One integrated D2D
• Server management logic
• I
2
C logic
FRU device ID accessed through a private I
2
C bus
Temperature sensor
A
D C D
B
TP00351
A. PCI slot 2
B. PCI slot 1 (on reverse side of board)
C. PCI slot 3
D. VDHM1 (left), VDHM0 (right)
Figure 19. PCI Riser Board Layout