User`s guide
Table Of Contents
- NovaScale 4020 User's Guide
- Preface
- Contents
- 1 System Description
- 2 Board Set Description
- 3 Configuration Software and Utilities
- Utilities / Drivers on Resource CD
- Power-on Sequence and Power-on Self-Test (POST)
- Extensible Firmware Interface Boot Manager
- The Extensible Firmware Interface (EFI) Shell
- BIOS Setup
- LSI Logic* SCSI Utility
- System Maintenance Utility
- EFI Platform Diagnostic Tests
- EFI Service Partition
- Console Redirection
- Terminal Mode
- Shutting Down the Server
- Servicing the System (basic knowledge)
- A Warning and Cautions
- B Working Inside the System
- C Hot-swapping System Components
- D Servicing the Electronics Bay
- Safety Warnings

System Description 7
Removable Media Drive Bay
CAUTION
The DVD/CD-ROM drive cannot be hot-swapped. In order to add,
remove or replace a DVD/CD-ROM drive, the system must be powered
down, power sources unplugged and the top cover of the chassis must be
removed to access the DVD/CD-ROM drive area.
The slim-line DVD/CD-ROM drive is installed in a drive carrier that is inserted from the rear of
the peripheral bay. This device is not hot-swappable; you must switch off system power,
remove all power cords, open the chassis and then remove the peripheral bay to remove or
install a CD-ROM or DVD-ROM drive.
The CD-ROM/DVD-ROM drive snaps into the carrier as shown below and is secured by four
raised points. The raised points line up with the mounting holes on the sides of the drive. Two
of these mounting points are spring loaded and two are stationary.
TP00303
Figure 7. DVD-ROM / CD-ROM Drive