User`s guide
Table Of Contents
- NovaScale 4020 User's Guide
- Preface
- Contents
- 1 System Description
- 2 Board Set Description
- 3 Configuration Software and Utilities
- Utilities / Drivers on Resource CD
- Power-on Sequence and Power-on Self-Test (POST)
- Extensible Firmware Interface Boot Manager
- The Extensible Firmware Interface (EFI) Shell
- BIOS Setup
- LSI Logic* SCSI Utility
- System Maintenance Utility
- EFI Platform Diagnostic Tests
- EFI Service Partition
- Console Redirection
- Terminal Mode
- Shutting Down the Server
- Servicing the System (basic knowledge)
- A Warning and Cautions
- B Working Inside the System
- C Hot-swapping System Components
- D Servicing the Electronics Bay
- Safety Warnings
System Description 3
External Chassis Features
System controls and indicators are located in several places on the chassis as follows:
• Chassis front:
Front panel: Front panel switches and LEDs
Peripheral bay: Hard drive LEDs
Power bay: Power Module LEDs and Power Supply LEDs
• Chassis back panel: System ID LEDs and LAN port LEDs
Each of these areas is discussed below.
Chassis Front
The following figure shows the front of the chassis with the snap-on bezel in place. The bezel
must be removed to access the front panel switches, power supplies, SCSI drives and DVD-
CDRW devices. Figure 3 shows the front of the chassis with the bezel removed.
Figure 2. Server System Front with Bezel Installed
TP00301
ACR AC2 AC1
PS + SHARED AC2/PS2 AC1/PS1
DE
B C
A
A. Hard drives B. CD-ROM/DVD-ROM drive
C. Front panel D. Power supply modules
E. Power bay F.
Figure 3. Server System Front with Bezel Removed