User`s guide
Table Of Contents
- NovaScale 4020 User's Guide
- Preface
- Contents
- 1 System Description
- 2 Board Set Description
- 3 Configuration Software and Utilities
- Utilities / Drivers on Resource CD
- Power-on Sequence and Power-on Self-Test (POST)
- Extensible Firmware Interface Boot Manager
- The Extensible Firmware Interface (EFI) Shell
- BIOS Setup
- LSI Logic* SCSI Utility
- System Maintenance Utility
- EFI Platform Diagnostic Tests
- EFI Service Partition
- Console Redirection
- Terminal Mode
- Shutting Down the Server
- Servicing the System (basic knowledge)
- A Warning and Cautions
- B Working Inside the System
- C Hot-swapping System Components
- D Servicing the Electronics Bay
- Safety Warnings
Safety Warnings 139
TP00353
B
A
C
D
A. Shield latch B. Shield
C. Touch point D. Insert card
Figure 62. Inserting a PCI Card
Installing the PCI Riser Assembly
CAUTION
When inserting the riser assembly, do not attempt to insert it at an angle.
Insertion at any other orientation other than vertical could result in
damage to the VHDM connectors.
1. Align the PCI riser card assembly with its mating slot on the retention lever assembly.
2. Lower the PCI riser assembly into position.
3. Move the PCI riser retention lever forward and down to engage the VHDM connectors and
seat the PCI riser assembly firmly into position.
4. Connect any peripheral cables that attached to PCI adapters installed in the riser assembly.
See the documentation that came with your PCI adapter for information.
5. Follow the instructions under Installing the Top Cover on page 127.
6. Reconnect any peripheral devices previously disconnected.