User`s guide
Table Of Contents
- NovaScale 4020 User's Guide
- Preface
- Contents
- 1 System Description
- 2 Board Set Description
- 3 Configuration Software and Utilities
- Utilities / Drivers on Resource CD
- Power-on Sequence and Power-on Self-Test (POST)
- Extensible Firmware Interface Boot Manager
- The Extensible Firmware Interface (EFI) Shell
- BIOS Setup
- LSI Logic* SCSI Utility
- System Maintenance Utility
- EFI Platform Diagnostic Tests
- EFI Service Partition
- Console Redirection
- Terminal Mode
- Shutting Down the Server
- Servicing the System (basic knowledge)
- A Warning and Cautions
- B Working Inside the System
- C Hot-swapping System Components
- D Servicing the Electronics Bay
- Safety Warnings
138 NovaScale 4020 User’s Guide
B
A
TP00320
A. Handle
B. Lift assembly straight up
Figure 61. Removing PCI Riser Assembly
Installing PCI Cards
1. With the PCI riser assembly removed, locate the slot into which the card is to be installed.
See the table below for information about the slots.
2. Open the lever over the shields (see letter “A” in Figure 62) to remove the shield (see letter
“B” in Figure 62).
3. Press down on the touch point on the PCI retention lever for the slot and swing the lever
open. See letter “C” in Figure 62.
4. Insert the adapter card and apply sufficient pressure to set the card into the slot. See letter
“D” in Figure 62.
5. Move the touch point and shield levers to the closed positions and snap to secure them.
6. Repeat steps 1 – 5 for each card to be installed.
Slot Connector PCI Bus Key Speed Form Factor
Slot 1
J9L1
(Pin Side)
Bus B 3.3 V 100 MHz PCI-x Long
Slot 2 J1A1
(Top Component Side)
Bus B 3.3 V 100 MHz PCI-x Long
Slot 3 J1A3
(Bottom Component Side)
Bus A 3.3 V 133 MHz PCI-x Long