User`s guide
Table Of Contents
- NovaScale 4020 User's Guide
- Preface
- Contents
- 1 System Description
- 2 Board Set Description
- 3 Configuration Software and Utilities
- Utilities / Drivers on Resource CD
- Power-on Sequence and Power-on Self-Test (POST)
- Extensible Firmware Interface Boot Manager
- The Extensible Firmware Interface (EFI) Shell
- BIOS Setup
- LSI Logic* SCSI Utility
- System Maintenance Utility
- EFI Platform Diagnostic Tests
- EFI Service Partition
- Console Redirection
- Terminal Mode
- Shutting Down the Server
- Servicing the System (basic knowledge)
- A Warning and Cautions
- B Working Inside the System
- C Hot-swapping System Components
- D Servicing the Electronics Bay
- Safety Warnings
Hot-swapping System Components 131
7. Position the carrier as shown Figure 57.
8. Place the drive in the carrier with the drive label-side up and the SCA (80 Pin) SCSI
connector end of the drive facing the back of the carrier. See letter “A” in the figure.
9. Align the holes in the drive to the holes in the drive carrier and drive rails. Insert the
mounting screws that were removed in the previous steps to and secure the carrier to the
drive. See letter “C” in the figure below.
10. Continue with the instructions under Installing a Hard Drive Carrier.
TP0031
7
B
A
C
A. Hard drive
B. Lower drive into carrier
C. Screws
Figure 57. Attaching the Hard Drive to the Carrier