User`s guide

124 NovaScale 4020 User’s Guide
Installing the Black Cover
To install the black cover on the server chassis, follow these instructions:
1. Hold the black cover at the front and at the rear and position it above the chassis of the
server.
CAUTION
The black cover is somewhat heavy (8 kgs)
2. Carefully lower the black cover, first at the front, in order that both sides of the black cover
position against the J-rails (see Figure 51) located on each side of the server.
Figure 51. J-rails
The front of the black cover must be about 1 centimetre back from the front of the server in
order that the 6 pins on the sides of the black cover insert inside the corresponding notches
located on the J-rails
3. After the front of the black cover is fully lowered, lower the rear of the black cover,
finishing by snapping it.
4. Slide the black cover forward by about 1 centimetre until the front of the black cover aligns
the front of the server
5. Install the 6 screws on the sides of the black cover and tighten them.
6. Put in place the front bezel.