User`s guide
Table Of Contents
- NovaScale 4020 User's Guide
- Preface
- Contents
- 1 System Description
- 2 Board Set Description
- 3 Configuration Software and Utilities
- Utilities / Drivers on Resource CD
- Power-on Sequence and Power-on Self-Test (POST)
- Extensible Firmware Interface Boot Manager
- The Extensible Firmware Interface (EFI) Shell
- BIOS Setup
- LSI Logic* SCSI Utility
- System Maintenance Utility
- EFI Platform Diagnostic Tests
- EFI Service Partition
- Console Redirection
- Terminal Mode
- Shutting Down the Server
- Servicing the System (basic knowledge)
- A Warning and Cautions
- B Working Inside the System
- C Hot-swapping System Components
- D Servicing the Electronics Bay
- Safety Warnings

Working Inside the System 123
B Working Inside the System
Handling the Black Cover on Desktop Models
On desktop models the server is equipped with a black cover. Figure 50 shows the black cover
removed.
Figure 50. NovaScale 4020 Desktop Black Cover
Before accessing inside the server, for example to add PCI boards, this black cover must be
removed.
Removing the Black Cover
To remove the black cover, follow these instructions:
1. Remove the front bezel from the server
2. Using a screwdriver, remove the 6 screws located on the sides of the black cover (3 on each
side).
3. Push the black cover back towards the back of the system, approximately 1 centimetre
towards the rear.
4. Lift the black cover, first at the rear, then at the front; and remove it.
CAUTION
The black cover is somewhat heavy (8 kgs)
Fr
o
nt
Rea
r