User`s guide

120 NovaScale 4020 User’s Guide
2 [7:4] - Output newline sequence (BMC to console). Selects what characters the BMC uses as the
<newline> sequence when the BMC writes a line to the console in Terminal Mode
0h = no termination sequence
1h = <CR-LF> (Factory default)
2h = <NULL>
3h = <CR>
4h = <LF-CR>
5h = <LF>
All other = reserved
[3:0] - Input newline sequence (Console to BMC). Selects what characters the console uses as the
<newline> sequence when writing to the BMC in Terminal Mode
0h = reserved
1h = <CR> (Factory default)
2h = <NULL>
All other = reserved
Shutting Down the Server
To shut down the server you must exit the operating system (if applicable) and then use the
power button to power down the server.
Follow these steps to power down the server.
1. If the server is running an operating system, use the operating system commands or GUI to
logoff if necessary and exit the operating system. Successfully exiting the operating system
causes the following prompt to appear:
Shell>
2. When this prompt appears, press and hold the power button for several seconds to power
down the server.
CAUTION
Powering down the server with the power button does not remove all power from the system.
The +5 V standby power is still available to the system even when it has been powered down.
To remove standby power from the system you must unplug both power cords from the chassis.