User`s guide

108 NovaScale 4020 User’s Guide
25. Click OK to exit out of this menu. Click Save to save the configuration.
26. Click OK at the User Save Result menu to return to the Home menu.
27. At the Home menu, click on the Exit option in the Navigation pane to exit SMU. Click
OK to confirm the exit.
28. Reboot the server.
Console Configuration
1. Boot the console into the operating system.
2. Launch HyperTerminal by clicking the Start button in the task bar.
3. Select Programs>Accessories>Communications and click HyperTerminal.
4. At the Connection Description window, enter guest for the name and click OK.
5. At the Connect To window, select the COM port of the console that the null modem is
connected. In this example, it is COM1.
6. At the COM1 Properties window, select 19200 for the Bits per second (Baud
rate) box to the SMU configuration on the server.
7. Select None for the Flow Control to match the BMC configuration.
8. Leave the default settings for the other boxes. Click OK to accept the settings and enter the
HyperTerminal screen.
9. The PING message sent by the BMC is displayed as characters on the HyperTerminal
screen.
10. Press the <ESC> key followed by <(> to enable Terminal Mode and end the PING
messages. [TMODE OK] is displayed.
11. Type [SYS TMODE], it is case sensitive and must be in uppercase. The response is [OK
TMODE] indicating that Terminal Mode is functioning.
Logging Into the Terminal Mode Session
Reminder: Guest was the password set for the Anonymous User in the BMC.
1. At the HyperTerminal screen enter [SYS PWD –N guest] to login. -N represents the
Anonymous User; guest is the password. This text is case sensitive.
2. The screen returns [SYS] and [OK] to indicate a successful login.
3. Type any supported terminal mode command.
4. To logout type [SYS PWD –X]
User Configuration
A user must be configured through the SMU to make full use of terminal mode. To create a
user, navigate to the SMU user configuration screen. Enter any username and password
combinations desired. Make sure to check the box that enables a particular user for use on the
serial channel. If this is not done, the username is not useable on the serial channel for terminal
mode. Configure the user with the desired maximum privilege level. See User Configuration
Sub-task on page 60 for details about the user configuration screens.
Spaces, left bracket characters or right bracket characters are not allowed in usernames or
passwords used with terminal mode.