User`s guide
Table Of Contents
- NovaScale 4020 User's Guide
- Preface
- Contents
- 1 System Description
- 2 Board Set Description
- 3 Configuration Software and Utilities
- Utilities / Drivers on Resource CD
- Power-on Sequence and Power-on Self-Test (POST)
- Extensible Firmware Interface Boot Manager
- The Extensible Firmware Interface (EFI) Shell
- BIOS Setup
- LSI Logic* SCSI Utility
- System Maintenance Utility
- EFI Platform Diagnostic Tests
- EFI Service Partition
- Console Redirection
- Terminal Mode
- Shutting Down the Server
- Servicing the System (basic knowledge)
- A Warning and Cautions
- B Working Inside the System
- C Hot-swapping System Components
- D Servicing the Electronics Bay
- Safety Warnings
Configuration Software and Utilities 91
Viewing FRUs
To view a FRU, click on the FRU title in the FRU display list. The FRU board, chassis, and
product areas are displayed on the right of the screen. If the area does not exist for the selected
FRU, the following message is displayed for that area:
Not present
Only the displayable FRUs are in the list. The name that is used in the list is taken from the
device locator record. If no displayable FRUs are present in the system, the title and value
areas will contain the following message:
Not present
The FRU list is replaced by the message:
No Displayable FRUs present in system
The FRU that is currently being shown on the right side of the screen will appear as a string in
the FRU list. It is not selectable.
Figure 47. FRU Viewer
Save To File Button
This button allows you to save the currently displayed FRU to a file. If the save fails because
the file cannot be created, this message is displayed:
Unable to create save file
If an error occurs while writing information to the file, this message is displayed:
Error saving the FRU data to the file