Specifications

Chapter 5 Function Parameter Simple List VFD‐G7 Series Frequency Inverter Operation Manual

47
Chapter 5 Function Parameter Simple List
Thefunctionparameters ofVFD‐G7seriesfrequencyinverterare organizedingroups. And
thereare16groupsfromF0‐FF.Eachfunctiongroupconsistsofseveralfunctioncodesthat
are identified by “Function Group No. + Internal Code Number”. For example, “F2.01”
indicatesgroup2anditsfunctioncodeis
1.
☞Notice1:ItcouldbeusedtoanyloadandyoushouldsetupF0.16、F0.17according
tothemotor’snameplate.
☞Notice2：VFD‐G7seriesfrequencyinvertersbeforefactoryistypeG(applytogeneral
usedload).IfthefrequencyinverterisusedastypePwitha
largegear(usedtothefanand
waterpumpload),thefunctioncodeF0.15mustbesetto1.
☞Notice3：VFD‐G7seriesfrequencyinverterbeforefactoryisV/Fcontrol.Ifthecase
needsabig torque,F0.14 canbesetto 0(available to<G200/P220KW,forvectorcontrol),
but F3.00 to F3.02 must be setup according to the motor’s nameplate, then the drive
auto‐learnsthemotor’sparameters
☞Notice4: “√” Indicatesthe parameter can be modified, no matter the drive runs or
stops;“×”meanstheparametercannotbemodifiedwhilethedriveisrunning.
“”indicates
theparametercanonlyberead.
Table1FunctionParameterSimpleList
Function
Code
Name
Setting Scope and
Introduction
Factory
Defaults
Modify Page
Group F0: Basic Running Parameters Group
F0.00
Selection of the
main frequency
source
0: Keyboard digital
frequency setting
1：Analog V1 setting
2：Analog V2 setting
3: Keyboard
3 × 93
F0.01
Selection of the
auxiliary frequency
source
0 × 93