Specifications

 Chapter6FunctionalParameterDetailVFD‐G7SeriesFrequencyInverterOperationManual

140
0：Respondforwriting
1：Norespondforwriting
The drive only responds the reading command of PC, and doesn’t responds the writing
command,whichcanimprovethecommunicationefficiency
6.10 F9 Group Human-computer Interface
F9.00 Key function setting
Default: 0000H
Setting scope：0000H～0034H
Single digit：Function selection of QUICK/JOG key
QUICK/JOG key is multi‐function key. The function of QUICK/JOG can be determined by
relativeparameters.
0:Jogoperation
QUICK/JOGkeyachievesjogoperation.
1:Switchbetweenforwardandreverse
UseQUICK/JOGkeytoswitchtheoperatingfrequencydirection.Itisvalidonlyinthe
QUICK/JOGkeyboardchannelcontrolmode.
2:ClearthesetUP/DOWNkeyisusedtoclearthepresetvalueofUP/DOWN.
3：Mainandauxiliaryfrequencysourceswitch
Main and auxiliary frequency source switch could be achieved through
QUICK/JOG key, when auxiliary frequency source is selected valid through
multi-function input terminal, this key would be without response.
4：Torquecontrolbanned/validswitch
Torque control and speed control under torque control could be switched through
QUICK/JOG key.
Decade：STOP/RESET key stop function selection
ThefunctioncodedefinesthevalidselectionofSTOP/RESETstopfunction.Itisalwaysvalid
forfaultresetinanycase.
0:validforpanelcontrol
1:Validforpanelandterminalcontrolinthesametime