Specifications

VFD‐G7 Series Frequency Inverter Operation ManualChapter 6 Functional Parameter Detail

135
reference.
Decade：PID feedback channel selection
0：AnalogV1feedback
1：AnalogV2feedback
2：Keyboardpotentiometersetting
3：Telecommunicationfeedback
4：HDIhighspeedpulsefeedback
ThisparameterisusedtoselectfeedbacksignalchannelofPID,ThefeedbackofprocessPID
istherelativevalue,thesettingrangeis0.0%~100.0%.
Hundred：PIDoutputcharacteristicselection

0: PID output is positive characteristic, when the feedback signal is larger than reference
valueofPID,theoutputfrequencyofthefrequencyinverterhastobeloweredtomakethe
PIDbalance,suchastensionPIDcontrol,watersupply,airsupplyPIDcontrol.
1: PID outputis negative characteristic,
when the feedback signal is bigger than reference
PIDvalue,thedriveshouldoutputtheupperlimitoffrequencytoholdthePIDbalance,such
astensionPIDcontrolofrewinding.
Single digit：Feedback broken line detection selection
0：Invalid
1：Alarmrun
FAULTindicatorlightflash,therunningfrequencyisfixedatthefrequencysetbyF7.08.
2：Faultstop
Fault(E022)。
Decade：Feedback overpressure protection selection
F7.01
Feedback signal protection
function selection
Default: 0000H
Setting scope ： 0000H ～
0022H