Specifications

 Chapter6FunctionalParameterDetailVFD‐G7SeriesFrequencyInverterOperationManual

114
bedisplayed,theLEDwillreturntheinterfaceinstandstillstate.Whenthedisplayed‐TUN‐
flashed,pressMODEkeycanexittheauto‐learning.
PressSTOP/RESETkeycanstoptheauto‐learningduringauto‐learning.
2:Parameterstationaryauto‐learning
The motor and load don’t need to disconnect in stationary auto‐learning. Values on the
motor’s nameplate (F3.00～F3.07) must be input correctly before starting auto‐learning.
After auto‐learning, the stator’s resistance, rotor’s resistance
 and the leakage inductance
can be detected, and exciting inductance and current without load can not be detected,
whichuserscaninputthecorrespondingparametersaccordingtheexperience.
☞Note: Only the panel can control the auto‐learning starting and stopping; after
auto‐learningending,thefunctioncodewillbeset
to0automatically.

F3.09
Proportional gain 1 o
f
speed-loop
Default：20 Setting scope：0.0～100
F3.10 Integral gain 1 of speed-loop
Default：0.50s Setting scope：0.0～10.00s
F3.11
The low frequency point to
switch
Default：5.00Hz Setting scope：0.00～F3.14
F3.12
Proportional gain 2 o
f
speed-loop
Default：25 Setting scope：0.0～100
F3.13 Integral gain 2 of speed-loop
Default：1.00s Setting scope：0.0～10.00s
F3.14
The high frequency point to
switch
Default：10.00Hz Setting scope：F3.11～F0.05
Theaboveparameterisvalidonlyforvectorcontrol,andinvalidforV/Fcontrol.Under
the low frequency point to switch (F3.11), the parameters of speed‐loop PI are F3.09 and
F3.10.Abovethehighfrequencypointtoswitch(F3.14),theparametersofspeed‐loopPIare
F3.12 and F3.13. Between
 the two switching points, the two groups of PI parameters will