User's Manual

77
**Note – whenever out of main screen – all lasers are off and laser outputs (including from
manual operation) are disabled**
This menu allows the user to edit or delete an individual event in the sequence.
In the event an initiation sequence is run that requires other devices, the device will go to
the default setting for End sequence.
Blink should produce the options of STDY (steady, no blinking), 0.25 (1/4 second blinking)
or 0.75 (3/4 second blinking)
The name displayed for the output in this table (space below the out put definition – R in
this example) will be pulled from the string assigned to the relevant output for that specific
custom scenario. It is not editable here, it is only displayed for reference purposes.
Selecting Delete should create a “Are you sure you want to delete this? pop-up to verify
the action before deletion.
Edit Custom Scenario Event
<< Edit Custom Scenario
Device ID MM
Output
R
On/Off?
ON
Blink? Y/N STDY
Time
XXX.XX
Delete/Cancel Event
<< Save and Return
Main Display > Settings > Drills + Custom Prog > Manage
Custom Scenarios > Edit Custom Scenario > Edit Event
--------------