User's Manual
76
**Note – whenever out of main screen – all lasers are off and laser outputs (including from
manual operation) are disabled**
This menu allows the user to edit device output definitions during custom scenario
generation.
When this menu is accessed by selecting “Add Device” from the Edit Custom Scenario
menu, the device ID is automatically assigned in chronological order (ie. 01,02,03,04 etc.).
To edit a specific device’s information its page must be accessed from the table on the
previous page (edit custom scenario).
Selecting Remove Device should create a “Are you sure you want to delete this?” pop-up to
verify the action before deletion. Devices can only be in order, because that is how devices
are linked to a master (or repeater) NURO
TM
. For example, a scenario cannot have devices
01, 03, 05. If a device is deleted (for example a scenario with devices 01, 02, 03, 04 has
device 03 deleted), the sequential devices above that will be re-numbered to fill the
sequence, the rest of the data (output definitions) will stay the same.
Default values for all visual outputs here for all added devices are undefined (------)
Edit Device (Custom Scenario)
<< Edit Custom Scenario
Device ID MM
Red
---------
Green
---------
Forrest ---------
Remove Device
<< Save and Return
Main Display > Settings > Drills + Custom Prog > Manage
Custom Scenarios > Edit Custom Scenario >> Edit Device