User's Manual

71
**Note – whenever out of main screen – all lasers are off and laser outputs
(including from manual operation) are disabled**
This menu allows the user to view or edit the end sequence for the drills.
This menu allows the user to change the ending sequence for the standard
drills (geezer mode). Default may not be edited. The only sequence in the
device is DEFAULT unless user programs new one(s).
Default ending is four audio outputs of .5s
Scrolling down and selecting each end sequence that has been created allows
user to edit and/or select the sequence.
Main Display > Settings > Drills + Custom Prog > Pre-set Drills
Change End
<< Pre-Set Drill Menu
+ New End Sequence
Select or Edit End Sequence
END000000001
END000000002
END000000003
END000000004
BobsEnd
END000000006
Main Display > Settings > Drills + Custom Prog > Pre-set Drills
> Change End Sequence
Current Sequence:
Default
DEFAULT