User's Manual

70
**Note – whenever out of main screen – all lasers are off and laser outputs (including from
manual operation) are disabled**
This screen allows the user to view drill content for each of the drills.
Appropriate colors should be applied to the table, just like on the main screen table.
Projection definitions should be displayed (if defined).
“Blink” should be based on the value assigned to the manual/drill modes in the device
menu. Default is S (steady)
Initiation (STRT) and END sequences apply as follows: Note that the start and
end sequences run on their own separate timelines.
Main Display > Settings > Drills + Custom Prog > Pre-set Drills
> Drill (XX)
Drill (XX)
<< Pre-set Drill Menu
Act Proj Blink Time
STRT ---- ---- XXX.XX
MMGON ---- ---- XXX.XX
---- ---- XXX.XX
MMRON ---- ---- XXX.XX
END ---- ---- XXX.XX
Initiator Sequence (ie. .5
sec audio)
Drill Timer Starts
End Sequence