User's Manual

61
**Note – whenever out of main screen – all lasers are off and laser outputs
(including from manual operation) are disabled**
This menu allows the user to Select the par time. Default is 000.00 for all
outputs.
The concept I’m working off of right now is that the user can use the arrow
buttons to move up/down on the “Audio/Red Laser etc.” section and left/right
from the output to the various time components (hundreds of seconds to
hundredths of a second). Once in the number section, the up/down arrows
will change the number. Open to any and all better ideas on how to do this.
In terms of what these actually mean from an output standpoint….
The user will hit the initiate/audio button. This will go through the delay (if
assigned – next menu) or straight into the par depending on those settings
(next menu).
For an audible par, it will function like this. Sound output fixed at .15sec – no
modulation.
For visual par (lasers) it will Function like this
Main Display > Settings > Set Par > Set Par Time
Red Laser
Set Par Time
<< Par Set Menu
Audio
Green Laser
XXX.XX
XXX.XX
XXX.XX
Forest Laser
XXX.XX
Sound Par Set
Time Period Defined (Par)
Initiate Sound
(.15s)
Finish (Par)
Sound (.15s)
I/A
Delay (if any)
Visual Par Set
Time Period Defined (Par)
Visual Stimulus
I/A
Delay (if any)