User's Manual

26
“Prog:” stands for “program”. This will display a string identifying the drill,
custom program, or (in post MVP versions) the downloaded scenario that is
being (or has been) run. Alternatively this may display the type of program,
program lists, or DRILL and RNDM (random) to indicate that the drills are run
in a random order.
Selecting this will open a menu of available drills, custom programs, or
scenarios, depending on the mode in use. The menu will allow for
configuration of the drill/program run and selection of the drill/program/list.
When in Manual mode, “None” is displayed because manual mode does not
involve the use of pre-programmed events.
Default: DRILL RNDM
Other Examples: LIST0000001 RNDM
LIST0000001 SEQ (Sequential run of a list)
00000001 – identification of a specific program selected
Clicking / selecting this tab opens a menu
The menu contains
1) A populated “Access Table” of up to 12? – More?? either lists or custom
programs – So you can have a queue of stuff to run through fast without going
into multiple layers of menu
2)Ability to select either a program or list to run and define whether or not its
going to run (in the case of lists) sequentially or in random order from within
the list or, alternatively, Drill Mode
If the user tries to program a list of scenarios, one of which contains more
devices than are linked, the user will be prompted with a warning and an
option to continue without all devices or abort.
Main Display
000.00
MSTR
YY DD MM
24HR
BATXXX%
R
G
F
Par: Off
Settings
Mode: Manual
Save
Prog: None
ID
ACT
SPLIT
TIME
XX
STRT
XXX.XX XXX.XX
ID
XXXX
SPLIT TIME
ID
ACT
SPLIT TIME
ID
ACT
SPLIT TIME
ID
ACT
SPLIT TIME
ID
ACT
SPLIT TIME
ID
ACT
SPLIT
TIME
ID
ACT
SPLIT TIME
Link: XX
ISO: XX
Ctrl: XXXXXXXX
XXXXXXXXXXXXX