Instructions / Assembly

7
Metal Roof
Slate Roof
– Use HipMaster .
– For use with standard and textural slates.
– Adapts to ridge pole or truss construction.
Standing Seam
Panel
D-Rib
Panel
Sheet Metal
Fastener
Sheet Metal
Fastener
D-Rib Metal
Closure
Underlay
Substrate
Nailer
Substrate
Underlay
1" Air
Opening
Metal Cap
TRUSS
CONSTRUCTION
Plus
®
Ridge Roll Cap
®
Metal Cap
Fastener
Nailer
Sealant
Tape
Slates
1/2" Air
Opening
1/2" Air
Opening
Underlay
Substrate
“Z” Flashing
®
®
Substrate
Underlay
Shingles
Ice & Water
Shield
Ice & Water
Shield
Nailer
1" Air
Opening
Metal Cap
Fastener
Ridge
Roll Cap
Fasteners
“Z” Flashing
Ridge Cap
®
1/2" Air
Opening
Ice & Water Shield
RIDGE POLE
CONSTRUCTION
– Use RidgeMaster Plus or HipMaster .
– For use with D-rib or standing seam roofs.
– Adapts to ridge pole or truss construction.
WOOD SHINGLE ROOFING
LAMINATE/WIDE BEAM
METAL ROOFING
®
®
Special Applications of and
Shingles
1x4 Nailer
Roofing
Nail
TRUSS
CONSTRUCTION
Wood Shingle Roof
SLATE ROOFING
Severe Weather Service
Normal Weather Service
For Residential, Commercial, New Construction or Reroofing
The following diagrams are intended as a general overview only. More extensive installation instructions are available
for these applications and others from Mid-America. Call Mid-America at 1-800-521-8486 for more information.
Full Shingle
1/2" Air
Opening
– Use HipMaster .
– Can be used with two types of shingles: Blue and
Red label No.1 and No.2 Fivex-Perfections-Royals.
– Adapts to ridge pole or truss construction.
– Use
RidgeMaster .
– To be used for wide ridge beams as often
found in cathedral ceilings, firewalls, etc.
– Remove baffles and end pieces from one
side of
RidgeMaster (see inset at right).
®
“D” Rib Standing Seam
Note: Cut off baffles on one
side of
RidgeMaster only.
Remove end piece to form flap