Installation Sheet

PAGE 1

Dual Mount Stainless Steel Sink

Installation Instructions

Before You Start

• Build Essentials recommends that all top mount sinks be installed by an experienced,

professional installer.

• IMPORTANT: The cabinet must be installed, secured, plumb, and level. Failure of this step can

lead to product damage.

• Build Essentials top mount sinks should only be fastened to a solid surface countertop

(i.e. granite, Corian® or Silestone®).

• Build Essentials is not responsible for sink or countertop if damaged during installation. Be sure

to inspect the sink for damage prior to beginning installation.

• Metal edges may be sharp – use caution when handling.

• Follow all local plumbing and building codes.

Recommended Tools & Materials (Not Included)

 Tape Measure

 Safety Glasses

 Painter’s Tape

 Level

 Framing Square

 Pencil (not permanent marker)

 Shims or Cabinet Fillers

 Denatured Alcohol

 Clamps

 Construction Adhesive

 Silicone Sealant

 Screws (recommended by countertop manufacturer)

Single Bowl Kitchen Sink

50/50 Double Bowl Kitchen Sink 60/40 Double Bowl Kitchen Sink

Single Bowl Kitchen Sink

PAGE 1
Dual Mount Stainless Steel Sink Installation Instructions Single Bowl Kitchen Sink Single Bowl Kitchen Sink 50/50 Double Bowl Kitchen Sink 60/40 Double Bowl Kitchen Sink Before You Start • Build Essentials recommends that all top mount sinks be installed by an experienced, professional installer. • IMPORTANT: The cabinet must be installed, secured, plumb, and level. Failure of this step can lead to product damage.
PAGE 2
Dual Mount Stainless Steel Sink Undermount Installation Instructions 1. Position the template (provided with your sink) front to rear so the sink QUTLINE FOR UNDERMOUNT SINK CUTOUT will not interfere with the cabinet; secure with tape. 1: Prep Countertop 2. Trace the template and remove. Dry fit the sink to verify the measurements. 3. Following the countertop manufacturer’s instructions, carefully cut the countertop on the inside of the traced line. 4.
PAGE 3
Dual Mount Stainless Steel Sink Top Mount Installation Instructions 1 2 PREPARING THE COUNTERTOP Position the sink (A) upside down on the countertop. Trace completely around the edge of the sink (A). Draw a line 5/16” inside of the outline of the sink. CUTTING THE COUNTER WARNING: Always wear safety goggles and gloves when using power tools to prevent personal injury. Drill a pilot hole in all four corners of the inside line. Use a saber saw or jig saw to cut on the inside line.