Specifications

Headlamp High/Low-Beam Changer
To change your headlamps from low beams to
high beams, or high to low, pull the multifunction lever
all the way toward you. Then release
it.
Flash-to-Pass
When the high beams are
on, this indicator light
located on the instrument
panel cluster will also
be on.
This feature lets you use your high-beam headlamps to
signal the driver in front of you that you want to pass.
It works even
if your headlamps are off.
To use it, pull the turn signal lever toward you a little,
but not
so far that you hear a click.
If your headlamps are
off or on low beam, your
high-beam headlamps will turn on. They’ll stay on as
long as you hold the lever toward you and the
high-beam indicator on the dash will come on. Release
the lever to return to normal operation.
Windshield Wipers
To operate the windshield wipers turn the band located
on the multifunction lever upward or downward.
WIPER: Turn this band to control the windshield wipers.
OFF: Turn the band to OFF to turn off the windshield
wipers.
LO (Low Speed): Turn the band away from you to LO
and past the delay settings for steady wiping at low
speed.
HI (High Speed): Turn the band away from you, to HI,
and past the delay settings for wiping steady at high
speed.
(Delayed Wiping): Turn the band away from you, just
past
OFF, to one of the five sensitivity settings, to
choose the delayed wiping cycle. The further the band
is turned upward, toward
LO, the shorter the delay
will be. Use this setting for light rain or snow.
3-8