Specifications

bühler

2500 Hayliner

CAUTION Make sure area is c lear of obstructions, well lit, and ha s

sufficient room for safe assembly.

CAUTION Ensure the 2500 Hayliner tires a nd hitch ar e securely block.

Otherwise, verify the 2500 Hayl iner is properly coupled to the drawbar on a tractor with

a minimum of 25000 LB (11340 kg).

Center Bale Stop

 Remove the hardware that is attached to the center bale stop a nd place c enter

bale stop bar on bolt plates in the position shown on page 3. Torque the provided

hardware to the spec ifications listed on the bolt char t. Tie wrap the hydraulic

hoses that run to the lift and tilt cylinders under the roll bar.

Fixed Lift Arm

NOTE: Hydraulic Assembly methods and layout s are common to the right and left

sides. Only one side of each component is shown in this manual.

CAUTION Stay clear of the arms when testing a finished ass embly.

Ensure during assembly to k eep your entir e body out from underneath parts that are

being attached to the main frame.

 Remove lif t arm pivot pins that are installed

on the 2500 Hayliner.

 Thoroughly lubricate all pins inv olved in the

assembly with a SAE multi purpose grease.

 Align arm to pivots with open end of arm

facing forward and reinstall pins with

hardware provided and torque to

specifications called for in the bolt chart.

 Remove the lift cylinder pin from the arm.

36.0"

FIXED LIFT ARM

ATTACHMENT

 Align the lift cylinder rod and reinstall the pin.

 Adjust the outside bale fork to be posit ioned at the end of the lift arm and the

inner bale fork about 36” (91 cm) from the end.

 Recheck all hardware so that every bolt ed connection on the lift arm is torqued

according to the specifications of the bolt chart.

 For first operation, cycle the lift arm slo wly with a bale and Inspect just before

lifting bale from ground.

 Approach the bale and inspect to ensure the spacing of the forks is accurate.

 Finish the cycle and observe how the bale transits from the forks to the carrier

beam. If transition is smooth wit h minimum bale binding assembly is completed.

If not adjust the forks to a different location and try until loading is smooth.