Operator`s manual

8. Secure the rear of each lower link bracket, 1, with

five M20 x 60 cap screws and M20 serrated flange

nuts, 2. Torque the hardware to 576 N⋅m (425 ft.

lbs.).

30000618

9. Using a proper lifting devise align the rockshaft

assembly, 1, to the rear frame of the tractor.

Secure the rockshaft with eight M20 x 90 cap

screws, M20 hardened washers and M20 flange

nuts, 2.

NOTE: The rockshaft assembly weighs approxi-

mately 227 Kgs (500 lbs.). Use caution when

installingtherockshafttotherearframeofthetractor.

10. Insert the cap screws and hardened washers

from the underside of the rear frame.

NOTE: The rockshaft is installed properly when the

feedback potentiometer is on the right hand side of

the tractor.

11. Torque the flange nuts to 576 N⋅m (425 ft. lbs.).

30000619

12. Install M20 jam nuts, 1, to six of the cap screws.

Do not install jam nuts to the two lower outside

cap screws, 2.

20000639

2 2