Operator`s manual

6
\
SECTION 1
MECHANICAL COMPONENT
INSTALLATION
1. Using a suitable jack, support the drawbar and
remove the two cap screws and washers, 1, for
the drawbar clevis, 2, and the cap screw and
washer,3,forthebridgeplate,4.Removethetwo
klik pins, 5, and the stanchion pins, 6, from the
bridge plate. Remove the bridge plate and clevis
from the drawbar. Allow the drawbar to hang
downward off of the drawbar cage.
30000612
2
3
1
6
5
4
7
2. Remove the tractor drawbar cage, 1, by
removing five of the six rear bolts, 2, and the two
front bolts, 3. Loosen the other rear bolt but do
not remove it at this time.
30000613
1
3
2
8
3. Align a lifting devise to the drawbar cage, 1, and
remove the bolt, 2, loosened in Step 2. Allow the
drawbarcage torestontheliftingdevice andpull
the cage away from the tractor.
NOTE: The drawbar cage is a very tight fit to the
tractor.Pullthecagestraightbackandawayfromthe
tractor.
The drawbar cage can be discarded at this time.
30000614
1
2
9