Operator`s manual

43
\
FEEDBACK POTENTIOMETER
1. Parkthetractoronalevelsurface,settheparking
brake and engage the articulation lock.
2. Engage the manual switch and raise the hitch to
the full up position.
3. Turn the engine off.
4. Measure the length of the exposed lift cylinder
rodfromthebaseoftherod,1,tothegreasezerk,
2.
5. Start the tractor and lower the 3--point hitch.
6. Engage the automatic mode of operation and
raise the hitch to the full up position
7. Turn the engine off.
1
2
112
8. Measure the length of the exposed lift cylinder
rod, 1. This measurement should be
approximately 6 mm to 5 mm (1/4″ to 3/16″)
shorter than the measurement obtained in step
4 of this procedure.
1
113