Operator`s manual

28. Snap the body, 1, back into the connector

housing. Orientate the body into the housing so

that the arrow on the face points toward the

connector wire opening as shown.

100

29. Position the seal and washer into the wire

opening and screw the adapter, 1, back into the

bottom of the connector housing.

101

30. Place therubber sealover the nose of therubber

connector, 1, and install the connector on to the

raise solenoid, 2. Install the center screw, 3, and

tighten securely.

NOTE: When assembled properly the connector will

point downward as shown so that rain water cannot

enter the wire connections. The solenoid valve has

a wide prong on it that only permits assembly in one

location. By installing the body into the connector as

detailed the connector will be orientated properly.

30000696

102