Operator`s manual

35
\
19. Connect the wiring harness adapter to the
controller, 1, and tighten securely. Connect the
wiringadapters forthe lowering rate controller,2.
1
2
91
20. Plug the two wire white connector, 1, (wires
TP-1B and TP-1A) onto the white connector on
the bottom of the fuse and relay panel. Make
certain that the connection is tight.
1
92
21. Route the 3-point hitch wiring harness down
through the rear access panel opening located
on the right rear of the cab floor.
Thread the harness through the horseshoe
shaped guide on top of the hydraulic manifold to
the implement valve assembly left hand side.
The branch of the harness that leads to the
feedback potentiometer, 1, is routed under the
implement valve assembly and down to the right
handcorneroftherockshaft.Theindividualwires
for the raise and lower solenoid, 2, should be
routed to the left hand side of the implement
valve.
Proper routing of the wire harness follows the
same path as the rear frame wire harness
currently occupies.
Pullany slack in the harness toward the cab right
rear opening. Pull the slack up inside the cab
floor, bundle it, and tie strap it.
Be certain that the harness is laying flat in the
right rear cab opening and will not be
compressed when the rear access panel is
reinstalled.
30000690
2
1
93