Operator`s manual

12. Place the three-point hitch wire harness below

the right hand side console and position the

harness with the connector for the manual

switch, 1, and auto indicator lamp wires, 2, up

through the center hole in the pocket.

30000688

13. Position the control panel, 1, on topof the pocket

and route the wiring for the command and

lowering rate potentiometers down through the

center opening in the pocket.

14. Attachtheconnectortothemanualswitch,2,and

install wire TP-1A to theside ofthe auto indicator

lampthat is stamped 12VDC. Thisis thepositive

side of the lamp. Connect wire TP3 to the

negative side of the light, 3.

30000689

15. When the wires are connected properly, place

the control panel, 1, on top of the right hand

consoleandsecureit withthetwocap screws,2,

which were removed in step #11 of this

procedure.