Operator`s manual

31
\
6. Remove the nuts and star washer from the stem
of the command potentiometer (five wire) and
install the stem, 1, through the face plate. Make
certain the locating tab, 2, is positioned properly.
Install the star washer and one nut, 3, to the top
of the command potentiometer.
NOTE:Thecommandandlower ratepotentiometers
may come with two nuts on the stem. Only use one
nut when installing the POTS to the face plate.
30000682
1
3
2
79
7. Remove the nuts and star washer from the stem
of the lowering rate potentiometer (three wire)
and install the stem, 1, through the face plate.
Makecertainthatthelocatingtab,2,ispositioned
properly. Install the star washer and one nut, 3,
to the top of the lowering rate potentiometer.
30000683
1
3
2
80
8. Install the auto indicator lamp, 1, into the face
plate from the top side of the control panel.
30000684
1
81