Operator`s manual

27. On 80 series HydraFlow, 82 Series, 84 Series

and 2000 Series install the supply line, 1, to the

check valve, 2, on the outlet end cap of the

implement valve.

NOTE: 80 Series non HydraFlow tractors do not

haveasupplylineonthissideoftheimplementvalve.

20000662

28. Locate the zero return line, 1, on the inlet side of

theimplement valve, 2. Cutthe tie strap securing

the line and remove and discard the cap, 3.

20000663

29. Install the straight fitting end of the jumper hose,

1, to the zero return line, 2. Route thehose tothe

rear of the valve stack and connect the elbow

end, 3, of the jumper hose to the straight adapter

in the rear of the three-point hitch valve block, 4.

This port is marked “OUT”. Tighten the fittings

securely.

Make sure that the zero return line and jumper

hose are routed under the implement valve

returnline,5,asshown.Ifitis notroutedthisway,

the implement valve shield will not fit.

NOTE: The tractor being worked on may have a

hydraulic option installed on it that is currently

occupyingthezeroreturnline.Procurefittingslocally

that will allow the solenoid drain line to attach to the

zero return line circuit.

20000664