Operator`s manual

On 9282, 9184 and 2240 tractors install the check

valve, 1, (which was removed in step 3 of this

procedure) into the open port of the elbow, 2, that is

screwed in to the outlet end cap. There is an o-ring

on the check valve that can be cut off and discarded.

The check valve is a multi purpose fitting (ORB and

JIC)andtheo-ringisnotusedtosealthisconnection.

Be certain that the check valve is orientated so that

the flow arrow on the check valve points toward the

implement valve.

NOTE: On 80 Series non HydraFlow tractors do not

have an elbow installed in this location. The male

adapter fitting (installed in step #15) is the only fitting

in the end cap.

30000707

26. On80Series HydraFlow,82, 84and 2000Series

tractors, install the solenoid valve jumper hose,

1, to the small adapter fitting, 2, on the outlet end

cap elbow. Connect the other end of the hose to

the elbow fitting, 3, installed in the “IN” port of the

three point hitch valve solenoid block. Tighten

the fittings securely.

20000660

On 80 Series non HydraFlow install the solenoid

valve jumper hose, 1, to the small adapter fitting, 2,

on the outlet end cap. Connect the other end of the

hose to the elbow, 3, fitting installed in the “IN” port

of the three point hitch valve solenoid block. Tighten

the fittings securely.

20000661